PROBE TEST Heat Probe Testing Tool 120W

PROBE TEST Heat Probe Testing ToolProbe-Test is an alternative to a gas torch or heat gun for testing Probe type Point Heat Detectors. Its advantages are particularly relevant when working in conditions where naked flame or exposed heating elements is unsafe or inconvenient. For example in roof spaces under floor spaces close to special wall or ceiling finishes. The heads reach a working maximum temperature of 520 Degrees Celsius.Key FeaturesHigh Power 120WNo Naked FlamesTests in SecondsTemperature ControlledFull Instructions IncludedThe heads reach a working maximum temperature of 520 Degrees Celsius.Available in 120v although lead times may be longer. Please Contact Us for more information.InstructionsThese instructions should be carefully followed each time the Probe-Test is used. Instructions using standard Point Type Heat Probes e.g. Fenwal Tyco Olsen T54B etc.Select appropriate heads for the diameter of detector probe shaft e.g. .Slide the heads onto the shaft until they bottom out. It is important that the heads do not slide easily off the shaft.Place Probe-Tester in a safe location. Switch ON at mains the indicator will glow Amber. Allow approximately 4 minutes to attain full working temperature.Position the two heated heads on the Probe-Test over the Heat Probe to be tested approximately 20mm from the end of the probe. Grip the handles firmly ensuring the heads remains at 90 degrees to the probe. Hold until the Heat Probe Detector actives.Remove Probe-Test from the Detector unplug from the mains and allow the Probe-Tester to cool.